Radio Shack PLVH7IP - Manual (Page 9)

Route the cable through the headrest
Run the supplied cable through the opening
and out to the bottom of the headrest. If possible,
conceal the wires with a shaft covering.
Connect the power, ground and video leads to
test the MONITOR.
Before connecting the monitor, pull the
connecting cable through the headrest shroud as
shown in diagram. Place the headrest housing into the
opening and secure with correct fasteners.
Install the headrest
Pull the connecting cable through the center of
the shroud as shown in diagram, and secure the
headrest shroud with correct fasteners shroud
Removal
headrest shroud gap and pull it out to remove the
monitor from headrest shroud.
Insert the release key between the monitor and
Insert the monitor
to the headrest shroud.
Push to insert the monitor
8