beautypg.com

Rockford Fosgate P550.2 User Manual

Page 4

background image

1. Power LED (Top of unit) – This Blue LED illuminates when the unit is turned on.
2. Thermal LED (Top of unit) – This Red LED illuminates if the amplifier reaches the third stage of

thermal protection.The amplifier will shut down to cool if this occurs.

3. Protect LED (Top of unit) – This Yellow LED illuminates if a short circuit or too low of an impedance

is detected at the speaker connections.The amplifier will automatically shut down if this occurs.

4. Cast Aluminum Heatsink – The cast aluminum heatsink of the Punch amplifier dissipates heat

generated by the amplifier's circuitry.

5. Speaker Terminals – The heavy duty, nickel-plated clamp wire connectors (+ and -) will accept wire

sizes from 8 AWG to 18 AWG.

6. Remote Bass (All models except P200.2) – Boosts low frequency information to overcome road

noise and put the bass in your face.The Remote Bass control is a narrow band adjustment at 45Hz

variable from 0dB to +18dB with a Gyrator based Punch EQ that eliminates frequency shift with boost.

Connection is made with a RJ-45 cable and can be installed in a variety of ways for easy control access.An

optional Para-Punch Remote Bass is available which adds an adjustable center frequency control with the

adjustable boost control.

7. Gain Control – The input gain control is preset to match the output of most source units. It can be

adjusted to match output levels from a variety of source units.

8. Variable Crossover – Is a built-in 12dB/octave Butterworth filter selectable for High-Pass (HP),All Pass

(AP), or Low-Pass (LP) operation variable from 40Hz to 400Hz.

9. RCA Input Jacks – The industry standard RCA jacks provide an easy connection for signal level input.

They are nickel-plated to resist the signal degradation caused by corrosion.

10. RCA Pass-Thru Jacks – The Pass-Thru provides a convenient source for daisy-chaining an additional

amplifier without running an extra set of RCA cables from the front of the vehicle to the rear amplifier

location.

4

D

ESIGN

F

EATURES

Connections

This manual is related to the following products: