Rockford Fosgate P550.2 - Manual (Page 12)

12
S
PECIFICATIONS
Specifications subject to change without notice
MODEL- PUNCH P550.2 P650.2 P850.2 P1200.2
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Per Channel 150 Watts x 2 175 Watts x 2 225 Watts x 2 300 Watts x 2
2 Load Per Channel 275 Watts x 2 325 Watts x 2 425 Watts x 2 600 Watts x 2
4 Load Bridged (Mono) 550 Watts x 1 650 Watts x 1 850 Watts x 1 1200 Watts x 1
Dimensions:
Height 2.1" (5.33cm) 2.1" (5.33cm) 2.1" (5.33cm) 2.1" (5.33cm)
Width 11" (27.94cm) 11" (27.94cm) 11" (27.94cm) 11" (27.94cm)
Length 13.7" (34.80cm) 16.4 (41.66cm) 17.7" (44.96cm) 17.7" (44.96cm)
Amplifier Fuse Rating (Amp/Type) (2) 30A / ATC (2) 40A / ATC (3) 40A / ATC (4) 40A / ATC
Battery Fuse Rating (Amp) External 60A 80A 120A 160A
(Not Supplied)
Signal-to-Noise Ratio >80dB A-weighted @ 2Vrms
Crossover Slope 12dB/octave Butterworth
Crossover Frequency variable from 40Hz to 400Hz
Frequency Response 20Hz to 20kHz ±0.5dB
Bandwidth 20Hz to 200kHz ±3dB
Slew Rate 30 Volts/µS
IM Distortion (IHF) <0.05%
Signal Voltage Adjustment Range Variable from 150mV to 4V (RCA Input)
Protection NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload, plus short
protection.Thermal switch shuts down the amplifier
in case of overheating.
Equalization (45Hz Punch Bass) (All models except P200.2) Variable from 0dB to +18dB @ 45Hz
Input Impedance 10k ohms
These specifications are Amplifier Power Standard CEA-2006 Compliant