Rockford Fosgate P550.2 - Manual (Page 11)

11
A
CCESSORIES
PUNCH Capacitors
Maintain the power you need to your Punch Amplifier.
PUNCH Install Kits
A variety of install kits are available to help you install your Punch amplifier like a professional.
Para-Punch Remote Bass Control
This adds an adjustable center frequency control with the adjustable boost control.
See our web site for other accessories to help you get the most out of your system.
www.rockfordfosgate.com
S
PECIFICATIONS
MODEL- PUNCH P200.2 P250.2 P325.2 P450.2
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Per Channel 50 Watts x 2 60 Watts x 2 80 Watts x 2 100 Watts x 2
2 Load Per Channel 100 Watts x 2 125 Watts x 2 160 Watts x 2 225 Watts x 2
4 Load Bridged (Mono) 200 Watts x 1 250 Watts x 1 325 Watts x 1 450 Watts x 1
Dimensions:
Height 2.1" (5.33cm) 2.1" (5.33cm) 2.1" (5.33cm) 2.1" (5.33cm)
Width 11" (27.94cm) 11" (27.94cm) 11" (27.94cm) 11" (27.94cm)
Length 11.7 (29.72cm) 11.7 (29.72cm) 11.7 (29.72cm) 11.7 (29.72cm)
Amplifier Fuse Rating (Amp/Type) (1) 30A / ATC (1) 40A / ATC (1) 40A / ATC (2) 30A / ATC
Battery Fuse Rating (Amp) External 30A 40A 40A 60A
(Not Supplied)
Signal-to-Noise Ratio >80dB A-weighted @ 2Vrms
Crossover Slope 12dB/octave Butterworth
Crossover Frequency variable from 40Hz to 400Hz
Frequency Response 20Hz to 20kHz ±0.5dB
Bandwidth 20Hz to 200kHz ±3dB
Slew Rate 30 Volts/µS
IM Distortion (IHF) <0.05%
Signal Voltage Adjustment Range Variable from 150mV to 4V (RCA Input)
Protection NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload, plus short
protection.Thermal switch shuts down the amplifier
in case of overheating.
Equalization (45Hz Punch Bass) (All models except P200.2) Variable from 0dB to +18dB @ 45Hz
Input Impedance 10k ohms
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice