Quick start, Connecting your radio, Cable radio signals – Radio Shack 12-1686 User Manual
Page 4
4
5
Quick Start
Connecting Your Radio
To avoid interference, keep the power supply away from the radio while in use.
Cable Radio Signals
The Radio’s FM antenna connector is a standard F-connector and will accept
cable FM feeds from most cable systems that provide FM programming. To
connect your radio to the FM signal from some cable TV providers, contact your
cable TV provider for assistance.
The installation must include a splitter that fi lters the signal to prevent any
re-emission of the RF spectrum through the radio, so only the FM band, not
the cable TV signal, is transmitted to the Radio. HD signals are not currently
rebroadcast via cable providers.
FM ANT
Connect FM antenna. Use the “T”
shaped antenna in
more remote areas.
AUX IN
Connect auxiliary devices with
headphone output. To listen to
auxiliary devices, select AUX mode.
DC IN
Plug the power supply into the
DC IN port, plug the AC cord into
the power supply, and then plug
the AC plug into the wall outlet.
AM Antenna
Press down the two
spring terminals,
connect the AM
antenna wires, and
position the antenna
for the best reception.