Revox M10 - Manual (Page 16)

M10 Re:system
15
RS232 interface
The serial interface is used
exclusively for configuring the
M10 and for installing new
firmware, if the USB or Ethernet
interface is blocked. It is not
possible to operate third-party
devices with it, nor is it possible to
connect external RS232
interfaces, e.g. EIB data interface.
You can only get access to the
M10 via its serial interfaces
through the Revox service
programmes M-Scope or M230.
Card slot for SD cards
A firmware update can be carried
out using an SD (Secure Digital
card.
SDHC cards > 2 GB are not
supported.
M-Link for Revox interfaces
The M-Link is a Revox interface,
which various Revox interfaces
can be connected to, e.g. M200
Domotic interface, M201 IR
interface, etc.
Both the RJ11 sockets are
electrically parallel switched.
You should only use a non-
crossed, 4-core telephone cable
with a RJ11 plug for this
connection (6P4C modular).
Headphone socket
The audio signal from the plug-in
modules in the M10 can be
listened to over the headphone
socket during installation. The
signal is also reproduced through
the M10’s integrated speaker as a
mono signal. In the case of
intrusive environmental noises, a
secure check of the audio signal
is possible using the headphone
output.
The output is made in stereo. The
source selection (plug-in module)
and the volume setting are done
through the Revox service
programs, e.g. M230.
- Socket for 3.5 mm jack plug
- Output rating: Max. 1 watt
- Impedance: > 16
Ω