RCA DRC620N - Manual (Page 5)

3
Graphics are for representation only. Your unit may differ slightly.
Connections and Setup
Installing the Battery
Removing the Battery
If you need to remove the battery in the future, use the following steps:
1. Slide the battery lock on the left side of the unit to the OPEN position to open the battery
compartment.
2. Use your thumb to press the battery release tab (on the right side of the battery
compartment) to the right. The battery releases and you can pull it out.
Installing the Battery in the Remote Control
Remove the battery holder from the remote control, insert a CR2025 battery, and reinsert the
battery holder into the remote control.
In order to avoid any risk of explosion,
observe polarities indicated inside the
battery compartment. Replace only with
the type of batteries specified above. Do
not throw them into fire, do not recharge
them. If you are not using the remote
control unit for an extended period (several
weeks), take the battery out.
CR2
02 5
1. Slide the battery lock on the left side of the unit to
the OPEN position to open the battery compartment.
2. Slide the battery into the compartment with the
battery labeling facing up and the arrow pointing
toward the unit. Push it all the way in until it snaps
into place.
Note: Contact the applicable local governmental office and your
current waste removal provider for assistance in determining the
appropriate disposal method in your area for old batteries.
To remove the battery holder from the remote, use your thumb to push the
release tab of the battery holder on the bottom of the remote to the right. Then,
while holding the tab to the right, pull out the battery holder with your index
finger.
Battery holder
Release
tab
OPEN
Battery lock
DRC620 book file 3 DRC620 book file 3 7/25/05 3:16:36 PM 7/25/05 3:16:36 PM