Rival IC500 User Manual

Page 5

– 9 –

– 8 –

PARTS AND ASSEMBLY (CONT.)

4. Place the COVER over the front

opening of the FREEZER
CANISTER while keeping the
RECIPE CHUTE at the top center
of the COVER.

5. Align each of the three LOCKING

CLIPS with each corresponding
BRACKET on the FREEZER
CANISTER. (See Fig.5)

6. Secure each LOCKING CLIP to

the corresponding BRACKET
and snap into place.
STEP 1: Place the end of the
LOCKING CLIP over the farthest
end of the BRACKET.
STEP 2: Pull the LOCKING CLIP
forward until it locks into place.
(See Fig.6)

NOTE: If preferred, the cover may be
attached to the CANISTER (step 4-6)
prior to attaching to BASE (step 3)
NOTE: Do not add liquid until
product is fully assembled and the
power switch has been turned on.

Fig.5

Fig.6

Step 2

Step 1

NOTE:
• Wash and dry all parts, except BASE (See Cleaning and Maintenance).
• Rival

Icey Cream Machine must be on a level surface to

function properly.

1. Place the FREEZER CANISTER in the freezer for at least 24 hours.

• Wash and dry canister thoroughly prior to freezing.
• Do not add ingredients until product is fully assembled and power

switch is on.

2. Prepare one of the included recipes (See RECIPES), or use your own.

Chilling the mixture beforehand is recommended.
CAUTION:
• Do not use the Rival

Icey Cream Machine to freeze liquids without

any sugar (such as water or sugar-free beverages) as this may
damage the appliance. Water will freeze very quickly to the interior
of the FREEZER CANISTER and could damage the unit.

• Pour any alcohol desired into the unit during the last 3-5 minutes

of freezing or dispense the drink first and add alcohol afterwards.

3. Take the frozen FREEZER CANISTER out of the freezer. Attach the

MIXING PADDLE to the inside of the CANISTER, attach the CANISTER
to the BASE, and secure the COVER (see assembly instructions).

Frozen Drinks

1. Plug the Rival

Icey Cream Machine into an electrical outlet and start

the motor by turning the power switch to the ON position.
• Make sure the DISPENSING LEVER is in a fully upright position

before turning the machine on or pouring in any liquid.

• Do not add liquid until the power switch has been turned on.

2. Carefully pour drink mixture into the RECIPE CHUTE. The liquid will

flow into the FREEZER CANISTER and you will begin to see it rotating
and freezing inside.

OPERATING INSTRUCTIONS

IC500_ICM_IB.qx 6/8/07 11:22 AM Page 8