Radio Shack 43-3812 - Manual (Page 18)

18 Answering System Operation
announces the day and time of the call at the
end of each message.
To play all messages after playing the new
messages, press
PLAY/STOP again.
To skip to the next message, press SKIP /
; ; ; ;
while the message is playing. Hold down
SKIP /
; ; ; ;
to fast forward through the
messages. Release SKIP /
; ; ; ;
to resume
normal playback.
To replay the current message from the
beginning, press
: : : :
/ REPEAT . Hold down
: : : :
/
REPEAT to review the current message. The
system skips back every other second of
playback and plays the previous second,
until the beginning of the message. Release
: : : :
/ REPEAT to resume normal playback.
If you press
: : : :
/ REPEAT within about 2
seconds (4 seconds during remote
operation) after a message begins playing,
the system replays the previous message. If
the current message is the first new
message, the system plays back from the
beginning of the current message (it does
not go back into the old message group).
ADJUSTING THE
ANSWERING SYSTEM’S
VOLUME
To adjust the speaker’s volume, repeatedly
press
VOLUME
8 8 8 8
or
9 9 9 9
on the base. The
volume setting from
&&&&
(lowest) to
////
(highest)
appears in the message counter window.
DELETING MESSAGES
To delete the current message while it is
playing, press
DELETE . The answering
system beeps.
To delete all messages, while messages are
not playing, hold down
DELETE on the base
until the system beeps and announces
“Messages have been deleted.”
&&&&
appears in
the message counter window.
Note: You cannot delete new (unplayed)
messages. If you try to delete all messages
while you still have new messages, the
system beeps and announces “Please play
back all messages.”
REMOTE OPERATION
While you are away from your home or
office, you can use a touch-tone phone, or a
pulse (rotary) phone with a pocket tone dialer
(available through your local RadioShack
store), to enter your security code and do
any of the following:
• Set the system to answer or not answer
calls.
• Listen to your messages.
• Record a new outgoing message.
• Record a memo.
• Erase messages.
You cannot remotely operate the system
using its handset or another telephone on
the same line as the system.
Setting the Security Code
The system’s two-digit remote operation
security code prevents unauthorized remote
access to your messages. The code is
preset to 80.
Follow these steps to change the code to any
number from 00 to 99.
1. Press MENU three times. The system
announces “Security code,” followed by
the currently set code. The display also
shows the code.
2. Press SET .