RedMax GZ400 - Manual (Page 36)

36
use. (F8-11)
(1) Normal operating mode
(2) Anti-freeze mode
(3) Cylinder cover
(4) ‘Sun shine’ mark
(5) ‘Snow’ mark
Continuing to use the product in anti-freeze mode
even when temperatures have risen and returned
to normal may result in the engine failing to start
properly or in the engine failing to operate at its
normal speed, and for this reason you should
always be sure to return the unit to normal
operating mode if there is no danger of icing
occurring.
■ HOW TO SWITCH BETWEEN OPERATING
MODES (F8-12)
1. Flip the engine switch to turn off the engine.
2. Remove the cover to the air filter, remove the air
filter, and then remove the choke knob from the
cylinder cover.
3. Loosen the screws holding the cylinder cover in
place (i.e., the three screws on the inside and the
one screw on the outside of the cover), and then
remove the cylinder cover.
4. Press with your finger down on the icing cap located
on the right-hand side of the cylinder cover to
remove the icing cap.
5. Adjust the icing cap so that the “snow” mark faces
upwards and then return it to its original position in
the cylinder cover.
6. Fix the cylinder cover back into its original position,
and then fix all other parts back into their proper
positions.
(1) Choke knob
(2) Cylinder cover
(3) Icing cap
WARNING
F8-12
(1)
(2)
8. Operation
English
F8-11