Radio Shack TAD-1007 - Manual (Page 20)

20
Note: The TAD sounds a 3-tone beep if you press a wrong button.
After you press 41 , 42 , 43 , or 44 (to play all messages), or 51 , 52 , 53 , or 54 (to play new
messages), you can enter the following commands.
Press Command Function
5 1
5 2
5 3
5 4 Play New Messages in
a Specific Mailbox (To
see what commands
you can use at this
point, see the table
below) Plays only new messages that have not already
been played. When new messages are recorded,
the TAD beeps, announces, “Mailbox __” and the
number of new messages, then plays them.
If there are no new messages, the TAD beeps and
says, “Mailbox (number), no new message.”
6 1
6 2
6 3
6 4 Delete All Messages If some messages (but no new messages) are
recorded in a specific mailbox, the TAD sounds a
short beep then a long beep and deletes all mes-
sages in that mailbox.
If new messages are recorded, the TAD
announces, “New messages” but does not delete
all messages. If no messages are recorded, the
TAD beeps and announces, “No Message.”
# Answer On/Off Sets the TAD to answer or not answer calls. The
TAD beeps and announces, “Answer on” or
“Answer off.”
Press Command Function
6 Delete Deletes the current message.
7 Replay Previous Replays the previous message.
8 Replay Replays the current message.
9 Skip Skips forward to the next message.
0 Stop Stops message playback.
43-747.fm Page 20 Friday, August 13, 1999 2:22 PM