Radio Shack TAD-1007 - Manual (Page 18)

18
2. Press SKIP or REPEAT to set the
first digit, then press STOP . The TAD
beeps and the second digit flashes.
3. Press SKIP or REPEAT to set the
second digit, then press STOP . The
TAD beeps and the third digit
flashes.
4. Press SKIP or REPEAT to set the
third digit, then press STOP . The
TAD beeps.
To see the new code, press and release
CODE .
REMOTE ANSWER-ON
Note: You must record an outgoing
message before you can remotely set
the TAD to answer calls.
Follow these steps to remotely set the
TAD to answer calls.
1. Dial your phone number.
If the TAD is set to answer-off, it
answers the call after 60 seconds
and announces, “Answer off.”
2. Enter the remote operation security
code within 8 seconds. The TAD
beeps.
Note: If you do not enter each digit
of the security code within 8 sec-
onds, the TAD hangs up.
3. Press # . The TAD beeps and
announces, “Answer on.”
4. You can hang up at this point and
have the TAD answer calls, or you
can enter other remote com-
mand(s) (see “Using Remote Com-
mands”).
43-747.fm Page 18 Friday, August 13, 1999 2:22 PM