Roland CUBE-100 User Manual

Page 11

Sample Settings

FUNK WAH (T.E)

This setting employs the T-WAH feature for a funky sound
that responds to the bass touch.

The wah effect becomes even more prominent with the T.E or
SESSION amp types, which feature response up to the high-
frequency range. Use the T-WAH knob to adjust the
sensitivity. Adjust the T-WAH effect with the knob settings
according to the output of the connected bass.

ROCK RIFF (CONCERT 810)

This is a fat, powerful standard bass sound.

Raise the HIGH-MID setting to produce a clear picking sound
when the bass is picked.

If you want a fatter low end, set the SHAPE switch to ON.

Raising the GAIN slightly results in an even fatter sound.

Applying the FLANGER produces a driving sound that goes
well with rock music.

OVER DRIVE (B MAN)

This setting gives the distorted sound produced by cranking a
tube amp up all the way.

You can set the GAIN position to create a huge range of
sounds, from light-distortion to deep-distortion overdrive.

You can then use the equalizer to create a wide range of
different tones.

You can get distortion with a fat, undulating sound by raising
the LOW-MID setting, while turning up the TREBLE and
HIGH-MID and turning down the BASS works to produce a
bright distortion sound.

Setting Name:

Use this for keeping notes regarding your settings.

.....................................................................................................

SHAPE switch: OFF

SHAPE switch: ON or OFF

SHAPE switch: OFF

OFF

SHAPE Switch

Set the VOLUME knob at appropriate volume level.

CB-100_e.book 11 ページ２００４年８月２７日　金曜日　午後２時１３分