RCA 27000 - Manual (Page 21)

Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels 2–13 appear in the TV’s memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using
CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
1. Place channels in
memory (Autoprogram)
2. Add or delete channels
13
Controls Alarm Adjust Setup
English Français Português
Autoprogram
Label: 13
Clear
Channel Memory: 13 Stored
Cable/Air: Cable
15
Controls Alarm Adjust Setup
English Français Português
Autoprogramming
Label: 13 Clear
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
English Français Português
Autoprogram
Label: 13
Clear
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
English Français Português
Autoprogram
Label: 13
Clear
Channel Memory: 13 Erased
Cable/Air: Cable
19
A. Hook up an antenna, cable
or components before you
begin these steps or you will
not be able to add channels
into memory.
B. Press MENU•PROG repeatedly
to select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press MOVE
̄ to highlight
Autoprogram.
D. Press MOVE
̈ to start the
TV adding all active channels
into memory.
E. Wait until the TV has cycled
through all the channels and
returns to the original channel.
A. Press MENU•PROG repeatedly
to select the Setup menu. This
menu is white.
B. Press MOVE
̄ to highlight
Channel Memory.
C. Press MOVE
̈ to underline the
channel number.
D. Select the channel number you
want to add or delete with the
number buttons.
E. Press MOVE
̈ to add or delete
a channel (you will see Stored
on the screen when added and
Erased when deleted).
F. Repeat D and E for more
channels.