Roland KC-60 - Manual (Page 10)

10
Using a Speaker Stand
By using a speaker stand, you can mount the KC-60 at the optimal height for use as a monitor speaker or simple PA device.
fig. Caution
● The KC-60 is designed to be used only with speaker
stands whose dimensions meet the specifications
described below.
Do not use it with a speaker stand that does not meet the
following specifications.
fig.05
fig.06_e
● When deciding on a stand to use with the KC-60, make
sure to pick one that is capable of supporting its weight.
● Before use, adjust the speaker stand to a height of 165 cm
(65”) or less and a leg spread of 120 cm (47-1/4”) or more,
as shown in the figure below.
fig.08\
● Using a speaker stand that does not meet the
specifications at left or that is adjusted to a height over
165 cm (65”), or a leg spread of less than 120 cm (47-1/4”)
may result in damage to equipment or injury due to the
stand tipping over.
● When using KC-60 with a speaker stand, the speaker
stand must be carefully placed so it is level and sure to
remain stable.
● Cables connected to KC-60 should be given enough slack
to prevent accidents that might result from someone
tripping over them.
● To prevent accidents due to falls, do not place any object
on the KC-60 when it’s mounted on a speaker stand.
● Always have at least one other person assist you when
mounting the KC-60 on a speaker stand, or when
adjusting the height of the stand while the KC-60 remains
mounted on it.
Leg spread: 120 cm (47-1/4”) or more
Diameter: 3.8 cm
(1-1/2”)
Diameter:
136 cm (53-9/16”)
or more
Leg spread: 120 cm (47-1/4”) or more
165 cm (65”)
or less
120 cm (47-1/4”) or more