RCA Color TV - Manual (Page 8)

6
The Channel Memory is the list of
TV channel numbers your TV will
stop on when you press the
CHANNEL up or down button. You
can program any list of channels into
the channel memory although your
TV is so automatic that you will
probably never need to manually
operate this feature. If you do,
follow the instructions at the right.
The first time you turn on the TV, it
cycles through all channels and
places active channels into the
channel memory. You can then add
or erase channels as desired by
following the instructions in the
“Editing Channel Memory” section
at the right.
1. Connect home antenna(s) or cable
to your set.
2. Press MENU on the TV front panel
until SETUP is highlighted. Press +
to select the SETUP menu.
3. Press MENU to highlight
AUTOPROGRAM.
4. Press + to begin AutoProgramming.
The TV cycles through all channels
and places only active channels into
memory.
5. When the TV finishes cycling, you
can check the channels in memory
by pressing CHANNEL up or down.
ANTENNA:CABLE
– AUTOPROGRAM +
EDIT CHANNELS
AUTOPROGRAM 24
Follow these instructions to erase and
add channels.
1. Press MENU on the TV front panel
until SETUP is highlighted. Press +
to select the SETUP menu.
2. Press MENU until EDIT
CHANNELS is highlighted. Press
+ to select EDIT CHANNELS.
3. Select the channel number by
pressing CHANNEL up or down.
When “+” appears next to the
channel number, the channel is in
the channel list. Press – to erase the
channel.
When “–” appears next to the
channel number, the channel is not
in the channel list. Press + to add
the channel.
4. Press – to erase or press the + to
add.
AUTOPROGRAM
ANTENNA:CABLE
– EDIT CHANNELS +
– ERASE / ADD +
12 –
Editing Channel Memory AutoProgramming Channel Memory
Notes:
• Signals from scrambled cable channels
and some cable channels having unusual
signal conditions may not be
autoprogrammed.
• To prevent the TV from losing its
channel memory, make sure the outlet
you plug your TV into is “on” all the
time. Do not plug the TV into an outlet
that can be turned on and off by a wall
switch. Also do not plug the TV into an
outlet on the back of another device
(such as a cable-TV converter box) that
is turned off when the device is turned
off.
• If there is an extended power failure,
your TV will automatically reprogram
active channels the first time you turn it
on after the power failure.
Operating Features
VIDEO
CAPTION OFF
– SETUP +
MUTE
VIDEO
CAPTION OFF
– SETUP +
MUTE