Rose electronic CRYSTALVIEW PRO CAT5 - Manual (Page 5)

INTRODUCTION
CRYSTALVIEW PRO CAT5 INSTALLATION AND OPERATINS MANUAL
1
Disclaimer
While every precaution has been taken in the preparation of this manual, the
manufacturer assumes no responsibility for errors or omissions. Neither
does the manufacturer assume any liability for damages resulting from the
use of the information contained herein. The manufacturer reserves the
right to change the specifications, functions, or circuitry of the product
without notice.
The manufacturer cannot accept liability for damages due to misuse of the
product or other circumstances outside the manufacturer’s control. The
manufacturer will not be responsible for any loss, damage, or injury arising
directly or indirectly from the use of this product.
System introduction
Thank you for choosing the Rose Electronics

CrystalView Pro
 CAT5 KVM
station extender. The CrystalView Pro CAT5 is a very versatile CAT5 KVM
extender. It supports the latest digital DVI as well as analog VGA. All
combinations of DVI and VGA monitors and video cards are supported.
With this flexibility, you can connect a VGA video card to a DVI monitor, or a
DVI video card to a VGA monitor.
The system consists of two Units, a transmitter and a receiver. The
transmitter connects to your CPU or a Rose switch and the receiver
connects to a keyboard, video monitor and mouse or KVM station. The
transmitter and receiver are connected together with CAT-5 industry
standard cable. The receiver can be up to 330 feet from the transmitter
using CAT5 cable.
The PC model is available with transmitter and receiver KVM access. The
transmitter KVM version allows an additional KVM station to be connected
to the transmitter unit.