Rose electronic CRYSTALVIEW PRO CAT5 - Manual (Page 22)

18
CRYSTALVIEW PRO CAT5 INSTALLATION AND OPERATIONS MANUAL
Applying power
Plug in the provided power adapters to a 110/220-volt source and to the
power connector on the transmitter and receiver Unit. Only use the power
adapter provided. GND and earth should not be connected. Mount ferrite
rings in the DC lines to protect against electromagnetic interference. Boot
up the connected CPU and wait for it to completely boot-up.
The two LEDs on each side of the CAT5 cable connector indicate the
following:
Red LED, communication status
ƒ Off – no communication errors
ƒ Slow blinking – one or more communication errors occurred over a 60-
minute period.
ƒ Fast blinking – Several communication errors occurred over a 60-minute
period.
Green LED, Link status
ƒ On – power is on and link connection is locked.
ƒ Blinking – CAT5 cable not connected or damaged.
The two LEDs next to the power connector indicate the following:
ƒ Both LEDs on – system booted correctly.
ƒ Only one LED on – unknown video mode being used.