RTS SSA-424 - Manual (Page 10)

10 SSA-424 U SER M ANUAL
2.4.3 C LEAR -C OM A UDIO C ONNECTION
1 Use standard Clear-Com 3-pin cables. Connect
one Clear-Com party line to the J1A connector
on the back of the SSA-424 (System A). Con-
nect a separate Clear-Com party line to the J1B
connector (System B).
✏ The SSA-424 features internal CD isolation.
You can therefore connect the SSA-424 to
powered Clear-Com cables, and it will not
draw any power from the Clear-Com system.
2 On the SSA-424 front panel, set the System A
and System B 2W CHAN SEL switches to
position 2.
✏ If the System A or System B hybrid will not
be used, set its 2W CHAN SEL switch to
either OFF position.
2.4.4 O
THER
2-
WIRE
A
UDIO
C
ONNECTION
1 Use the J1A connector on the back of the SSA-
424 to connect one 2-wire line to the System A
hybrid. Use the J1B connector to connect a
second 2-wire line to the System B hybrid. The
pin configuration for the J1A and J1B connectors
depends on whether you are connecting a
balanced or unbalanced 2-wire line:
Balanced Configuration
Pin 1: No connection
Pin 2: Balanced Audio + Input/Output
Pin 3: Balanced Audio - Input/Output
There are two possible configurations for unbal-
anced connection:
Unbalanced Configuraton 1
Pin 1: Audio Common
Pin 2: Audio + Input/Output
Pin 3: No connection
Unbalanced Configuration 2
Pin 1: Audio Common
Pin 2: No connection
Pin 3: Audio + Input/Output
2 On the SSA-424 front panel, set the CHAN SEL
switches as follows:
• Balanced Configuration: set the CHAN SEL
switches to the BAL position
• Unbalanced Configuration 1: set the CHAN
SEL switches to position 1.
• Unbalanced Configuration 2: set the CHAN
SEL switches to position 2.
✏ If the System A or System B hybrid will not
be used, set its 2W CHAN SEL switch to
either OFF position.