Mp3 & wma disc operation, Aux in & rca output – Roadmaster VRCD220S User Manual

Page 15

MP3 & WMA Disc Operation

that “TRK” will blink on the display.
Then use the VOL +/- Button to choose
your desired track and press the SEL
Button again to confirm the selection. The
selected track will be searched for and
then played.

3. File Search
Press the F/PS Button twice and the
display will show “FILE SCH”. Press the
SEL Button to enter the root folder of the
disc. Use the VOL +/- Button to choose a
folder in the root folder, then press the SEL
Button to confirm. The selected folder will
be opened.

4. Character Search
Press the F/PS Button three times and
the display will show “CHAR SCH”. This
is for files by file names. Press the SEL
Button and the first character will blink
on the display. Use the VOL +/- Button to
change the character. Press the SEL but-
ton once to confirm the character entered
and advance to the next character. After
you have input the name, press and hold
the SEL Button to confirm. The song near-
est alphabetically to the name input will be
found and then begin to play.

AUX IN & RCA Output

1. Auxiliary Input
The Auxiliary Input RCA Jacks are on the
rear of the unit. To use the AUX IN feature
you must use a RCA to 3.5mm cable.
Insert the cable’s RCA plugs into the Red &
White AUX IN jacks on the rear of the unit.
Route the end of the cable with the 3.5mm
jack to an area that is safe and convenient
to the headphone jack of any external
audio device such as walkman and disc-
man. Press the “Mode” button to choose
AUX. Connect any portable audio device
such as a DVD player or VCD player to the

AUX IN cable. Use the volume control to
adjust volume.

2. RCA Output
The RCA Output Jack is on the back of the
unit. (Refer to Wiring Diagram) This output
is for connecting amplifier, equalizer, or
other audio component that requires a
pre-amp out connection. (Red = Right,
White = Left)
Follow the manufacturers instructions for
the audio component that you are con-
necting.

Maintenance
Cleaning the Unit
Do not use any liquids to clean this unit.
Do not use petroleum distillates to clean
this unit. Use a clean, dry cloth to clean
this unit.

Replacing the Fuse
Make sure the amperage matches the
specified value when replacing the fuse(s).
If the fuse is bad, check the power connec-
tion and replace the fuse with a new one. If
the same problem occurs, this might indi-
cate a malfunction within the unit.

Warning
When replacing a fuse, do not use a fuse
with a higher amperage rating than the
fuse originally supplied to your unit, other-
wise damage will result to your unit.

VRCD220S English PROOF Manual.indd 15

10/15/08 11:34:19 AM