RedMax SGCX2600S - Manual (Page 18)

■ ADJUSTING THE MAXIMUM SPEED
• The screw at the throttle lever is for adjusting the
maximum speed. (OP6)
• Turning the screw crock-wise, the rpm becomes
down, the otherwise, the rpm becomes up.
(STANDARD OPERATION SPEED: 8000~9500
rpm)
Running engine with faster engine speed than
9500 rpm may damage the engine, slower
engine speed than 8000 rpm may cause of the
poor cutting ability.
(1) adjust screw (2) down (3) up
• Too large play causes wire out from the position.
Too small play causes throttle lever does not
stay at idling position.
■ USAGE
This machine does cutting not by a rotary cutter
like conventional trimmers but by a pair of special
blades, each upper blade and lower blade oscillate
opposite direction alternately within a limited angle
at a speed of approximately 1/30 of conventional
trimmers.
This unique mechanism brings you many benefits
like the following:
1. Since the blade does not cause grass chips and
pebbles to the thrown around, you may use less
care about your clothing or surroundings.
2. Should the blade hit a rigid object like stones,
trees or steel poles during operation, it does not
produce a bounce motion that can cause loss of
machine control.
3. Since the blade does not cause cut grass to
wrap around the neck, you need not to stop
operation to remove such wrappers.
What's more, since the whole circle of the blade is
available for cutting, you can move the cutting
head in all directions and cut grass growing on
such place difficult-to-get with conventional
trimmer.
You can even trim the waterside without splashing
IMPORTANT
7. Operation
❲ 18 ❳
RECOMMENDED APPLICATIONS:
Parking area
Among trees
Near fences
Road side
OP6