Regency P131 User Manual

Page 2

Regency P121-1/P121LC-1/P121RC-1/P131-1 Zero Clearance Direct Vent Gas Fireplace

To the New Owner:

Congratulations!
You are the owner of a state-of-the-art Gas Fireplace by REGENCY. The P121/
P121LC/P121RC/P131 is a hand crafted appliance and has been designed to provide
you with all the warmth and charm of a wood ﬁ replace at the ﬂ ick of a switch. The
model P121/P121LC/P121RC/P131 has been approved by Warnock Hersey for both
safety and efﬁ ciency. As it also bears our own mark, it promises to provide you with
economy, comfort and security for many trouble free years to follow. Please take a
moment now to acquaint yourself with these instructions and the many features of
your Regency Fireplace.

IMPORTANT: If the unit is to be installed into a bathroom, optional Neo ceramic glass
Part# 360-946 Front or Part# 360-948 Side must be purchased and installed in place
of the tempered glass supplied with the unit.

MANUFACTURED MOBILE HOME REQUIREMENTS

INFORMATION FOR MOBILE/MANUFACTURED HOMES AFTER FIRST SALE

This Regency product has been tested and listed by Warnock Hersey as a Direct Vent Wall Furnace to the following standards:
VENTED GAS FIREPLACE HEATERS ANSI Z21.88a-2000/CSA 2.33a-2000 and GAS-FIRED APPLIANCES FOR USE AT HIGH
ALTITUDES CAN/CGA 2.17-M91.

This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and the Manu-
factured Home Construction and Safety Standard, Title 24 CFR, Part 3280, or the current Standard of Fire Safety Criteria for
Manufactured Home Installations, Sites, and Communities ANSI/NFPA 501A, and with CAN/CSA Z240-MH Mobile Home Standard
in Canada.

This appliance installation must comply with the manufacturer's installation instructions and local codes, if any. In the absence of
local codes follow the current National Fuel Gas Code, ANSI Z223.1 and the current National Electrical Code ANSI/NFPA 70 in the
U.S.A., and the current CAN/CGA B149 Gas Installation Code and the current Canadian Electrical Code CSA C22.1 in Canada.

This Regency mobile/manufactured home listed appliance comes factory equipped with four 1/4" diameter holes located near each
corner of the base. Fasten the ﬁ replace in place using screw, inserted through the holes.

This appliance comes equipped with a dedicated #8 Ground Lug for attachment of the ground wire to the steel chassis as applicable
to local codes. See page 28.

The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with
the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.

This appliance may only be installed in an aftermarket permanently located, manufactured (U.S.A only) or mobile home, where not
prohibited by local codes.

This appliance can only be used with the type of gas indicated on the rating
plate. This appliance is not convertible for use with other cases, unless a
certiﬁ ed kit is used.

Ensure that structural members are not cut or weakened during installation.