Radio Shack TAD-799 - Manual (Page 9)

9
PREPARATION
SETTING THE DAY AND
TIME
Follow these steps to set the day and
time so the TAD records the correct day
and time of the call with each phone
message.
Notes:
• To avoid having to reset the time if
AC power is lost, we recommend
you install a battery before you set
the day and time.
• If you do not complete any step
within 8 seconds, the TAD sounds a
three-tone beep and stops setting
the day and time. Start over at Step
1
1. Press and hold SET until the TAD
beeps. The TAD announces, “Sun-
day,” and
01 appears on the dis-
play.
Note: If necessary, adjust VOLUME
on the right side of the TAD to the
desired listening level.
2. To change the day of the week,
repeatedly press REPEAT to move
backward or SKIP to move forward
until the TAD announces the
desired day of the week.
3. Press STOP . The TAD beeps once
and announces the time format,
“AM” or “PM.”
4. To change the hour, repeatedly
press REPEAT until you hear the
desired hour.
5. Press STOP . The TAD beeps once
to confirm the hour setting.
6. To change the minutes, repeatedly
press REPEAT until you hear the
desired minute setting.
7. Press STOP to confirm the settings.
The TAD beeps and announces the
day and time.
To check the current day and time at
any time, press
SET .
43-799.fm Page 9 Monday, August 16, 1999 9:43 AM