Radio Shack XMODS 60-440 User Manual

Page 3

www.xmodsRC.com

Place the center gear back on

the center shaft. Lightly press

and rotate the center gear so the

flat side of the center shaft and

the center gear mesh.

Restore the center shaft with center gear into the

original position and rotate center gear so the front

center gear meshes with the shaft.

Reinstall the third gear, then align the drive shafts

and restore the rear differential gear unit as shown.

If you have installed the All Wheel Drive kit:

Remove the center gear and the center shaft and

replace the small bearing. Tweezers may be helpful

for this step.

Align the shafts of the rear arms and reassemble

the rear gear case.

Replace the bearing on its both ends of the

differential gear. If you have installed the All

Wheel Drive kit, skip to Step 11.

Align the drive shaft and restore the rear differential

gear unit as shown.

Align the shafts of the rear arms and re-assemble

the rear gear case.

Remove the two screws on the rear drive unit

to remove the rear gear case. Then, remove the

differential gear and the third gear.

Re-assemble the motor, the motor holder, and the

motor connector. If you have NOT installed the

All Wheel Drive kit, this completes the upgrade.

Align the drive shaft to the joint cup and

reassemble the wheel shafts with the drive shaft

installed into the knuckles. Then, replace the

knuckle caps/disk brakes and wheels. Unless you

have installed the All Wheel Drive kit, your front

wheels do not have a drive shaft/joint cup, so just

reassemble the front wheel shaft.

Remove the two screws on the motor connector

and the two screws on the motor cover and detach

the motor.