Regency C34-NG2 - Manual (Page 27)

Regency CLASSIC C34-2 Direct Vent Freestanding Gas Heater 27
WIRING DIAGRAM
INSTALLATION
This heater does not require a 120V A.C. supply
for operation. In case of a power failure, the
burner switch and the optional remote control/
thermostat will continue to operate.
However, a 120V A.C. power supply is needed
for the fan/blower operation.
CAUTION: Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
CAUTION: Ensure that the wires
do not touch a hot surface and
are away from sharp edges. WARNING:
Electrical Grounding
Instructions
This appliance is equipped with
a three pronged (grounding)
plug for your protection against
shock hazard and should be
plugged directly into a properly
grounded three-prong recepta-
cle. Do not cut or remove the
grounding prong from this plug.