Radio Shack 43-3801 - Manual (Page 13)

13 Operation
outgoing message or recording an incoming message and
resets to answer another call.
Notes:
• If the system’s memory is full, it answers calls after 10
rings. The caller hears “No one is available to take your
call,” the system sounds a beep, and the caller cannot
leave a message. The system cannot record additional
messages until you delete some of the old messages (see
“Deleting Messages” on Page 17).
• Many local phone companies use CPC to signal that the
caller has hung up. Your system can recognize a CPC
signal and release the line. If the system records phone
company messages or dial tones, your local phone
company probably does not use CPC.
USING ANNOUNCE-ONLY
Announce-only sets the system to play a message for the caller,
then automatically disconnects without letting the caller leave a
message.
To select announce-only, slide INCOMING MSG to ANN ONLY .
When the system receives a call, it answers after two rings and
plays the announce-only message, a long beep sounds, then it
monitors the phone line for remote codes received within about
10 seconds.
You can use the system’s prerecorded announce-only OGM
“No one is available to take your call,” or record your own.
43-3801a.fm Page 13 Monday, February 25, 2002 8:56 AM