RoyalTek RFG-1000 - Manual (Page 6)

6
Start-Up for RFG-1000( RS-232 & USB)?
Getting Started
Step 1: Plug-in RS-232 or USB cable to your laptop or desktop PC.
Step 2:Install USB driver if you use USB cable to connect RFG-1000 to your PC.(for
detail , please go to USB driver installation for Windows Operation System)
Step 3:Install & run RoyalTek GPS Driver program.(for detail, please refer
RoyalTek GPS Driver installation and RoyalTek GPS Driver operation )
Step 4:Choose the correct COM port and baud rate (4800bps) for map or navigation
software.
Notice:
(1) For safety reason, please do not install RFG-1000 while driving.
(2) The formats of NMEA messages are illustrated on Software Data section.
(3) It is strongly recommend that user doesn’t plug and unplug this connector
frequently.
RS-232
PS2