NordicTrack CX 938 NEL5095.0 User Manual

Page 19

HOW TO REMOVE THE SIDE SHIELDS AND THE

FLYWHEEL COVERS

The Left and Right Side Shields (15, 16) must be

removed before the reed switch or the drive belt can

be adjusted. To remove the Side Shields, remove the

indicated Screws (48, 94, 95). Note which hole each

Screw is removed from; the Screws will later need to

be reattached in the same holes. Carefully separate

and remove the Side Shields.

Next, the Right

and Left

Flywheel Covers

(18, 19) must be

removed.

Remove the

indicated

Screws (48, 69)

from the

Flywheel

Covers. Note

which hole each

Screw is

removed from; the Screws will later need to be reat-

tached in the same holes. Carefully separate and

remove the Flywheel Covers.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. To adjust the reed

switch, first see the instructions at the left and remove

the side shields and the flywheel covers.

Next, see the drawing below. Locate the Reed Switch

(55). Turn the Left Crank Arm (34) until the Magnet

(37) is aligned with the Reed Switch. Loosen, but do

not remove, the indicated Screw (94). Slide the Reed

Switch slightly closer to or away from the Magnet, and

then retighten the Screw. Turn the Left Crank Arm for

a moment. Repeat until the console displays correct

feedback. When the Reed Switch is correctly adjust-

ed, reattach the side shields and the flywheel covers.

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance is adjusted to the highest

setting, the drive belt may need to be adjusted. To

adjust the drive belt, first see the instructions at the

left and remove the side shields and the flywheel

covers.

Next, see the drawing above. Loosen the indicated

Bolt (75). Turn the indicated Screw (74) clockwise

until the Drive Belt (39) is properly tightened, and then

retighten the Bolt (75). Then, reattach the side shields

and the flywheel covers.