NordicTrack CX 938 NEL5095.0 User Manual

Page 10

Note: The console

can show speed and

distance in either

miles or kilometers.

The letters MPH or

Km/H will appear in

the lower display to

show which unit of measurement is selected. To

change the unit of measurement, first hold down

the Start button for a few seconds. An E (for

English) or an M (for metric) will appear in the

lower display. Press the 1 Step Resistance 10 but-

ton to change the unit of measurement. Note:

When the batteries are replaced, it may be neces-

sary to reselect the desired unit of measurement.

While you are select-

ing a unit of mea-

surement, you can

also select a back-

light mode. The “On”

mode keeps the

backlight on while the

console is on. The “Off” mode turns the backlight

off. To conserve the batteries, the “Auto” mode

keeps the backlight on only while you are exercis-

ing. Press the 1 Step Resistance 1 button to

change the backlight mode if desired. Then, press

the Start button.

Measure your heart rate if desired.

If there are

thin sheets of

plastic on the

metal con-

tacts on the

handgrip

pulse sensor,

peel off the

plastic. To

measure your

heart rate,

hold the handgrip pulse sensor, with your palms

resting against the metal contacts. Avoid moving

your hands or gripping the contacts tightly.

When your pulse is

detected, your heart

rate will be shown in

the lower display. For

the most accurate

heart rate reading,

hold the contacts for

at least 15 seconds.

Note: If you continue to hold the handgrip pulse

sensor, the lower display will show your heart rate

for up to 30 seconds. The display will then show

your heart rate along with the other modes.

If your heart rate is not shown, make sure that

your hands are positioned as described. Be care-

ful not to move your hands excessively or to

squeeze the metal contacts too tightly. For opti-

mal performance, clean the metal contacts using

a soft cloth; never use alcohol, abrasives, or

chemicals.

Turn on the fan if desired.

To turn on the fan at

low speed, press the

Auto Breeze Fan but-

ton; the number 1 will

appear next to the

word “Fan” in the dis-

play. To turn on the

fan at medium speed, press the button a second

time; the number 2 will appear. To turn on the fan

at high speed, press the button a third time; the

number 3 will appear. To select the Auto mode,

press the button again; the words “Auto Fan” will

appear. When the auto mode is selected, the

speed of the fan will automatically increase or

decrease as you increase or decrease your ped-

aling speed.

To turn off the fan, press the Auto Breeze Fan

button again. Note: If the pedals are not turned

for a few minutes, the fan will automatically turn

off.

Slide the thumb tab on the right side of the fan to

pivot the fan to the desired angle.

When you are finished exercising, the console

will automatically turn off.

If the pedals are not moved for several seconds, a

tone will sound, the console will pause, and the

time will begin to flash in the upper display.

If the pedals are not moved for about five min-

utes, the console will turn off and the displays will

be reset.

Contacts