NorthStar Navigation 10 kW - Manual (Page 45)

3. Confirm the type of radar installed:
ƒ 2 kW dome
ƒ 4 kW dome
ƒ 6 kW open array
ƒ 10 kW open array
ƒ 25 kW open array
4. Make sure the voltage input and radar processor are correct for the system being installed, as
follows:
ƒ 2 kW - 12 V DC - Radar Processor NS004780
ƒ 4 kW - 12 V DC or 24 V DC - Radar Processor NS004781
ƒ 6 kW - 12 V DC or 24 V DC - Radar Processor NS004782
ƒ 10 kW - 24 V DC - Radar Processor NS004783
ƒ 25 kW - 24 V DC - Radar Processor NS004784.
4.6.1.7 Are Range Rings displayed?
Yes, range rings are displayed.
1. Confirm that the installation set up had been performed.
2. Verify that the array is turning. If it's a dome, with the power off, remove the dome cover
(weather permitting). Apply power to the system. After the warn-up countdown has
completed, and the transmit option is set to ON, verify that the array is turning.
3. If the antenna does not turn, skip to the section "If the scanner fails to turn".
No, range rings or range scale information are not displayed.
1. Verify that the serial data cable wiring is correct for the communications cable as shown in
the section "Connect the communications cable to the junction box".
Northstar 10 kW Radar Installation Manual 45