NorthStar Navigation 10 kW - Manual (Page 2)

1.1 FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a normal installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
ƒ Reorient or relocate the receiving antenna.
ƒ Increase the separation between the equipment and receiver.
ƒ Connect the equipment into an output on a circuit different from that to which the receiver
is connected.
ƒ Consult the dealer or an experienced technician for help.
ƒ A shielded cable must be used when connecting a peripheral to the serial ports.
1.2 Industry Canada
Operation is subject to the following two conditions (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation
of the device.
Refer also to the system specifications section.
1.3 Compliance Statement
EMC compliance:
USA (FCC): Part 15 Class B
Refer also to the system specifications section.
Northstar 10 kW Radar Installation Manual 2