NISSAN 2010 Murano - Manual (Page 6)

4
HEADLIGHT AND TURN SIGNAL CONTROL
TO AcTiVATe THe AuTOLiGHT SYSTeM
(if so equipped):
Turn the headlight control switch 01
to the AUTO position to
activate the autolight system. The autolight system can:
Turn the headlights on automatically when it is dark.
Turn the headlights off automatically when it is light.
keep the headlights on for 45 seconds after you turn the
ignition switch to Off and all doors are closed.
TO deAcTiVATe THe AuTOLiGHT SYSTeM:
Turn the headlight control switch 01
to the OFF,
or position.
HeAdLiGHT cOnTROL SWiTcH
Turn the headlight control switch 01
to the
position to turn on the front parking, tail,
license plate and instrument panel lights.
Turn the headlight control switch 01
to the
position to turn on the headlights. All other
lights remain on.
01 02
WINDSHIELD WIPER/WASHER SWITCH
The ignition switch must be in the On position to
activate the windshield wipers.
Move the lever to the following positions to operate
the windshield wipers:
1A
intermittent (INT) – Push the lever down. front
wipers operate intermittently and can be further
adjusted by twisting the time control ring
1B
.
1A
Rain-Sensing intermittent (if so equipped)
(AUTO) – Push the lever down. front wipers
operate intermittently and adjust speed
automatically depending on rainfall and vehicle
speed. Sensitivity of the intermittent rain-sensing
feature can be further adjusted by twisting the time control ring
1B
.
02
Low Speed (LO) – Push the lever down for continuous low-speed operation of front wipers.
03
High Speed (HI) – Push the lever down for continuous high-speed operation of front wipers.
04
Mist (MIST) – Push the lever up for one sweep of the front wipers.
05
Rear Wipers (REAR) – Twist the end section to operate the first (INT) or second (ON)
speed settings for the rear wipers.
The washer function activates the washer fluid and several sweeps of the wipers:
• For FRONT WASHER, pull the lever toward you.
• For REAR WASHER, push the lever away from you.
1A
02
03
05
1B
04