Synchronizing the sdi output to an external source, Genlock versus frame lock, Using genlock – Nvidia Quadro FX 5500 User Manual
Page 42: Using frame lock, Supported synchronization signals
NVIDIA Corporation
38
Quadro FX 4500/5500 SDI User’s Guide– Version 2.0
C
HAPTER
4
Linux—Using the Graphics to Video Out Control Panel
Synchronizing the SDI Output to an External Source
You can synchronize the SDI output with other equipment in a broadcast or post
production environment.
Genlock Versus Frame Lock
The Graphics to SDI page provides two methods for synchronizing the SDI output to a
common sync source—Genlock and Frame lock.
Using Genlock
Genlock synchronizes the pixel scanning of the SDI output to an external synchronization
source.
When using genlock, the SDI refresh rate is determined by the sync source, so any refresh
rates that you may have chosen in the Output Video Format list do not apply.
Using Frame Lock
Frame lock synchronizes the frame rate of the SDI output to an external synchronization
source.
When using frame lock, only modes that are valid for the frame rate of the sync source can
be used for the SDI output. The valid modes will appear in the Output Video Format list.
Supported Synchronization Signals
NVIDIA Genlock supports the following external synchronization signal types:
• SDI
• Composite Bi-level (NTSC or PAL sources use bi-level composite signals.)
• Composite Tri-level (HDTV sources commonly use tri-level composite signals.)