Time and date settings, Call settings, Time and date settings call settings – Nokia 3120 User Manual
Page 33: Call divert, Speed dialling, On pag, Speed, Dialling

U s i n g t h e m e n u
24
Copyright © 2004 Nokia. All rights reserved.
Time and date settings
Press
Menu
, and select
Settings
,
Time and date settings
.
Select
Clock
to set the phone to
show the clock in standby mode,
adjust the clock and select the time
format.
Select
Date
to set the phone to show
the date in standby mode, set the
date, the date format and the date
separator.
Select
Auto-update of date & time
(network service) to set the phone to
update the time and date according
to the current time zone.
The automatic update of the date
and time does not change the time
that you have set for the alarm clock,
calendar or the alarm notes. They are
in local time. Updating may cause
some alarms that you have set to
expire.
Call settings
Call divert
Press
Menu
, and select
Settings
,
Call
settings
and
Call divert
(network
service) to divert your incoming
calls. For details, contact your
service provider.
To set the divert setting to on, select
Activate
, and then select the
timeout after which the call is
diverted, if this is available for the
divert option. To set the divert
setting to off, select
Cancel
. To check
whether the call divert is activated
or not, select
Check status
, if this is
available for the divert option.
Several divert options may be active
at the same time.
Anykey answer
Press
Menu
, and select
Settings
,
Call
settings
and
Anykey answer
. Select
On
and you can answer an incoming
call by briefly pressing any key,
except
, selection keys
and ,
and .
Automatic redial
Press
Menu
, and select
Settings
,
Call
settings
and
Automatic redial
. Select
On
and your phone will make up to
ten attempts to connect the call
after an unsuccessful call attempt.
Speed dialling
Press
Menu
, and select
Settings
,
Call
settings
and
Speed dialling
. Select
On
and the names and phone
numbers assigned to the speed
dialling keys, from
to
, can
be dialled by pressing and holding
the corresponding number key.