Installing software, Installing software -8 – NETGEAR Digital Entertainer EVA700 User Manual
Page 20
Digital Entertainer Model EVA700 User Manual
1-8
Installing Your Digital Entertainer
v1.0, May 2006
3. Connect the digital entertainer power cord and plug it into an outlet.
4. The LED on the front of the digital entertainer lights up to show that it is
powered on.
5. Install the two AA batteries into the remote control that shipped with the
product.
6. Use the remote control to turn on the television.
7. The television displays “Do you want to use the Viiv network setup?”
If you do not see this message, aim the remote control at the digital
entertainer, and push TV mode. You can cycle through the TV modes to get
the best display.
Windows XP Computer Without Intel® Viiv™ Technology
After you connect the digital entertainer, you complete the installation in the
following order:
1. Use the NETGEAR CD to install the software. See “Installing Software” on
2. Set up the digital entertainer. See “Setting up the Digital Entertainer” on
Installing Software
Follow these steps to install the software on your Windows XP computer.
1. Power on your computer and log in as needed.
2. Insert the NETGEAR CD into the CD drive on the computer.