Navigon PNA 2110 - Manual (Page 38)

User's manual NAVIGON 2100 | 2110
- 38 - Working with the map
Simulation: Simulates a navigation based on the displayed route. This
simulation can be performed without GPS reception. Simulation is,
however, restricted to routes of max 60 mi.
Rename: Opens a window in which you can change the name for the selected
destination or route.
Traffic: Opens the T RAFFIC I NFORMATION window in which pending reports are
listed. For detailed information, please refer to chapter "TMC (Traffic
Information)" on page 46.
Show Turn-by-Turn List: Shows detailed directions for the route, including all
points at which you must turn.
For more detailed information, please refer to chapter "Turn-by-Turn
List" on page 45.
Factory Settings: Opens a window in which you can reset all settings to the
original factory settings.
Delete Destination: Deletes the highlighted destination from the list (L AST
D ESTINATIONS or F AVOURITES ). A dialog window prompts you to confirm
deletion.
Save Destination: Saves the specified address in the F AVOURITES list.
For more detailed information, please refer to chapter "Saving a
destination" on page 31.
Add to Route: Opens route planning. The address specified will be added as the
first route point of a new route.
For more detailed information, please refer to chapter "Routes with
stages" on page 32.
9 Working with the map
9.1 Maps
Even if you have stored several navigation maps on the navigation
system's memory card, NAVIGON 2100 | 2110 can only operate with
one map at a time.
Tap on Options > Settings > Current Map to see which map is currently
being used. You can also select another map here.
9.2 Map in Preview mode
You have entered a destination and tapped the Start Navigation button.
- OR –