Nvidia N61S - Manual (Page 27)

- 2 -
nVIDIA N61P/N61S/N61V User's /Manual
OnChip IDE Channel 0
The mainboard chipset contains a PCI IDE interface with support for two IDE channels.
Select “Enabled” to activate the first and/or second IDE interface. Select “Disabled” to
deactivate an interface if you are going to install a primary and/or secondary add-in IDE
interface.
Primary Master/Slave PIO
Each IDE channel supports a master device and a slave device. These four items let you
assign the kind of PIO (Programmed Input/Output) were used by the IDE devices.
Choose Auto to let the system auto detect which PIO mode is best, or select a PIO mode
from 0-4.
Primary Master/Slave UDMA
Each IDE channel supports a master device and a slave device. This mainboard supports
UltraDMA technology, which provides faster access to IDE devices. If you install a device
that supports UltraDMA, change the appropriate item on this list to Auto. You may have
to install the UltraDMA driver supplied with this mainboard in order to use an UltraDMA
device.
IDE DMA transfer access
This item allows you to enable the transfer access of the IDE DMA then burst onto the
PCI bus and nonburstable transactions do not.
Serial-ATA Controller
Available options: [Disabled] [Enabled]
IDE Prefetch Mode
The “ onboard” IDE drive interfaces supports IDE prefetch function for faster drive
access. If the interface on your drive does not support prefetching, or if you install a
primary and/or secondary add-in IDE interface, set this option to “Disabled”.
• Back to Integrated Peripherals Setup Menu
► RAID Config
Click key to enter its submenu:
RAID Enable
Available options: [Disabled] [Enabled]
SATA 1/2 Pri-Master/Primary/Secondary/Primary RAID
This option allows you to enable or disable SATA Primary/Secondary RAID.
This is configurable only when “RAID Enable” is set to “Enabled”.
• Back to Integrated Peripherals Setup Menu
・
Onboard Lan Chip
This option enables or disables the LAN controller.
Phoenix - AwardBIOS CMOS Setup Utility
RAID Config
RAID Enable
x SATA 1 Pri-Master RAID
x SATA 1 Secondary RAID
x SATA 2 Primary RAID
x SATA 2 Secondary RAID
[ Disabled ]
Disabled
Disabled
Disabled
Disabled
Item Help
Menu Level
►►
↑ ↓
→←
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Disabled