Newcon Optik DAY/NIGHT VISION SCOPE NVS 10MG User Manual

Page 16

place the ON/OFF switch into the position OFF;

Visibility decreases and / or disappears.
Bright light sources (moon, projectors or headlights) may
result in visibility degradation or even complete
disappearance. If this happens move the scope away from
the light source immediately. The image should be restored
in within 2 minutes.
Poor atmospheric conditions such as fog haze or extremely
dark environments will decrease the visibility distance as
well.
-

Place the handle DAY/NIGHT (9) into the position
DAY;

Open the cover (7) by turning the latch (8) clockwise;

Take out the battery pack (5);

Place two charged batteries or two AA cells into the
battery pack (5), observing the marked polarity;

Locate the groove on the top side of the pack and place
it into the compartment. The battery pack must slide
effortlessly into the compartment;

Close the cover (7) by turning the latch (8) counter
clockwise.

Put the light filter (1) on the objective (2). Set the
DAY/NIGHT handle (9) into the position NIGHT, turn
on the ON/OFF switch (10) and put the hand wheel (3)
into the middle position. You should see the aiming
marks on the yellow-green background;