Newcon Optik DAY/NIGHT VISION SCOPE NVS 10MG User Manual

Page 15

6.2 General Instructions

Prior to usage, be sure that you understand the sight controls
and fixing mechanism.
If the sight was in storage, clean optical components with
napkin. Remove the lubricant from the metallic surfaces.
In conditions that require high level of camouflage at night
time, set the protected eyeshade on the sight in the following
order:
-

unclasp the clutch (15) (figure 2);

take off the eyeshade (16) together with the clutch (15);

put the eyeshade (16) into the case;

take the protected eyeshade from the kit;

put the clutch (15) on the eyeshade;

fit the eyeshade to the eyepiece frame, stretching it a
little;

fasten the clutch.

If the outside temperature is below zero, keep the battery
pack in the inner pocket of your clothes.
Check the voltage of the single battery in the following
order:
-

place the power supply into the battery control module,
keeping the polarity right up;

if any LED is on, the battery is charged, if it is not, then
the battery is discharged and must be replaced.

Install the battery pack on the sight in the following order: