Network Computing Devices Wireless Ethernet Adapter GW-EN11H - Manual (Page 21)

GeoWave GW-EN11H Wireless Ethernet Adapter User's Manual
21
The Server Tab
IP Address Mode: Select “Static” or
“DHCP” mode. For “Static” mode,
the IP address settings are given by
user. For “DHCP” mode, IP settings
will be overridden by a DHCP server
on your network. The default setting
is “Static”
IP Address: The static IP address
you want to assign to the adapter.
The default value is “192.168.1.100”.
IP Subnet: The subnet mask you
want to assign for the adapter. The
default value is “255.255.255.0”.
IP Gateway: The gateway you want
to assign for the adapter. The default
value is “192.168.1.1”.
Allow upgrade uploads: Check the
box, and then it is allowed to
upgrade firmware.
Note! You may need to reboot the adapter, and then re-load the page to see
any new settings.
The Admin Tab
Change password: Default
password is “admin”. For security
concerns, please change it after
finish the configuration.
Reboot Adapter: When any setting
was changed, the adapter MUST be
reboot so that the change can be
confirmed.
Reset to factory defaults: This
option will ERASE all the current
settings, and restore to the factory
default settings.
Note! You may need to reboot the adapter, and then re-load the page to see
any new settings.