Napoleon Fireplaces GD82PT-T - Manual (Page 2)

2
W415-0583 / B / 05.23.07
PG 2-5 INTRODUCTION
Warranty
Dimensions
General Instructions
General Information
Care of Glass & Plated Parts
5-9 VENTING
Vent lengths
Venting Specifi cations
Air Terminal Locations
10-15 INSTALLATION/FRAMING
Wall & Ceiling Protection
Using Flexible Vent Components
Fireplace Vent Connection
Using Rigid Vent Components
Gas Installation
Restricting Vertical Vents
Framing
Clearance to Combustibles
Mantle Clearances and Enclosures
15 ELECTRICAL CONNECTION
Hard Wiring Connections
Schematic
16-18 FINISHING / SERVICING
Door Removal
Burner Assembly Removal
Battery Replacement
Blower Replacement
Bowl, Mesh & Rock Replacement
19 NIGHT LIGHT TM REPLACEMENT
19-23 OPERATION / MAINTENANCE
Time Out
Fireplace Operation
Hand Held Remote Operation
Dip Switch Number Chart
Operating Instructions
24 ADJUSTMENTS
Pilot Burner Adjustment
Venturi Adjustment
25 CONVERSION KIT
26-27 REPLACEMENTS
Replacement Parts
Flexible Vent Kits
Terminal Kits
Roof Terminal Kits
Accessories
Replacement Parts Diagram
28-29 TROUBLE SHOOTING GUIDE
30 SERVICE HISTORY
31 NOTES
WARNING
• Do not burn wood or other materials in this fi replace.
• Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to
avoid burns or clothing ignition. Supervise young children when they are in the same room as the fi replace.
• Clothing or other fl ammable material should not be placed on or near the fi replace.
• Due to high temperatures, the fi replace should be located out of traffi c and away from furniture and draperies.
• Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.
• Even after the fi replace is out, the glass and/or screen will remain hot for an extended period of time.
• Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces.
These screens and guards must be fastened to the fl oor.
• Any safety screen or guard removed for servicing must be replaced prior to operating the fi replace.
• It is imperative that the control compartments, burners and circulating blower and its passageway in the fi replace and
venting system are kept clean. The fi replace and its venting system should be inspected before use and at least annually
by a qualifi ed service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding mate-
rial, etc. The fi replace area must be kept clear and free from combustible materials, gasoline and other fl ammable vapours
and liquids.
• Under no circumstances should this fi replace be modifi ed.
• This fi replace must not be connected to a chimney fl ue pipe serving a separate solid fuel burning appliance.
• Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service technician to inspect the
fi replace and to replace any part of the control system and any gas control which has been under water.
• Do not operate the fi replace with the glass door removed, cracked or broken. Replacement of the glass should be done
by a licensed or qualifi ed service person.
• Do not strike or slam shut the fi replace glass door.
• This fi replace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by
Wolf Steel Ltd.
• Pressure relief doors must be kept closed while the fi replace is operating to prevent exhaust fumes containing carbon
monoxide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause
the surrounding combustible materials to overheat and catch fi re.
TABLE of CONTENTS
PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE