Dip switch settings – Net Optics PA-CU-AR User Manual
Page 14
10/100 Port Aggregator Tap
10
DIP Switch Settings
Switch
Function
Description
1
Turns Auto-negotiation ON
or OFF. Factory default
setting is Auto-negotiation.
If turned ON, ports A, B, and C/D automatically
negotiate the links. Positions thru are inac-
tive.
To manually configure ports A, B, and C/D, turn
switch to the OFF position. Positions thru
are active.
Set Port A Duplex
ON for Half-Duplex; turn OFF for Full-Duplex
Set Port A Speed
ON for 10 Mbps; turn OFF for 100 Mbps
Set Port B Duplex
ON for Half-Duplex; turn OFF for Full-Duplex
Set Port B Speed
ON for 10 Mbps; turn OFF for 100 Mbps
6
Set Port 1 (and ) Duplex
ON for Half-Duplex; turn OFF for Full-Duplex
Set Port 1 (and ) Speed
ON for 10 Mbps; turn OFF for 100 Mbps
Active Response
Turns Active Response ON or OFF
AUTO
NEGOTIATE
ON
OFF
NOTE: To activate, push buttons UP.
(This diagram shows all segments
in the OFF position)
ON
OFF
10
100
HD
FD
10
100
HD
FD
10
100
HD
FD
Active
Response
A
C
B
1
3 4 5 6 7 8
2
/
.
Figure 9: DIP Switch Settings