Cabling guidelines, Connecting to the network, Figure 7: connecting to the network – Net Optics PA-CU-AR User Manual
Page 12
10/100 Port Aggregator Tap
Cabling Guidelines
Use.straight-through.cable.to.connect.the.Tap.Ports.to.a.Router.or.NIC ..Use.
cross-over.cable.to.connect.the.Tap.Ports.to.Switches.and.Hubs ..The.Tap.Ports.
Transmit.on.Pins.3.&.6.and.Receive.on.Pins.1.&.2 .
Note: ________________________________________________________________
You must ensure that both Network Ports A and B match speed and duplex
settings on your network devices.
______________________________________________________________________
Connecting to the Network
1 .. Connect.Network.Port.A.to.the.appropriate.network.device.following.the.
cabling.guidelines.above ...
2 ...Connect.Network.Port.B.to.the.appropriate.network.device.following.the.
cabling.guidelines.above ..
3 .. Verify.that.the.Tap.Network.Ports.are.cabled.in-line.between.two.devices .
Figure 7: Connecting to the Network
2
2
B
1
1
A
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
®
1
2
www.netoptics.com
2
2
B
1
1
A
Passive Dual
Port Aggregator with
Active Response
Passive Dual
Port Aggregator with
Active Response
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
10
100
LINK
ACT
®
1
2
www.netoptics.com
To network switch or router
To network switch or router