Newcon Optik LAM 3 IR User Manual

Page 16

Mounting LAM on a weapon



Mount LAM on the Picatinny rail using the quick

release lever mount (9, Fig. 1) so that the laser
emission is directed towards the target;



If desired, connect the remote switch cable to the

connector (16, Fig. 2) and tighten the nut. Fix the
remote switch on the weapon pivot or grip by Velcro
tape in place, which would be comfortable for
pressing the key. Trim the tape if necessary.

Adjusting LAM on a weapon

LAM can be adjusted on a weapon using two techniques:


with laser boresight and boresight target;



with iron weapon sight and special target.

In both cases you will need a night vision device, a
boresight target and a gun rest (or its substitute).
If the weapon is boresighted using field means (sandbags,
rucksacks) and the weapon is laid on its side for stability,
turn the boresight also.
Prior to adjusting LAM, which has never been in
operation, carry out 10 shots to stabilize the adjustment
mechanisms under the influence of recoil.
Adjusting with help of laser boresight