Reference, Troubleshooting – NAD C426 User Manual

Page 12

CONDITION

POSSIBLE CAUSES

POSSIBLE SOLUTIONS

No power.

• The power cord is disconnected.

• Plug the power cord into the wall outlet

securely.

No sound.

• Power AC lead unplugged or power not

switched ON.

• Check AC lead is plugged in and power

switched on.

• Signal leads incorrectly connected.

• Check connections to amplifier.

• Station not selected or weak signal with FM

MUTE

• Re-tune or deactivate FM MUTE.

Noisy reception, hiss.

• Weak signal.

• Check station tuning. Adjust or replace

antenna.

Reception with whistling, buzzing noise.

• Interference from other computers, games

consoles.

• Check station tuning. Switch off or move the

source of electrical noise.

No RDS information.

• Station signal too weak.

• Check station tuning. Adjust or replace

antenna.

• Station not transmitting RDS data.

• Tune to an RDS station that supports program-

service name (PS mode) and radio-text (RT

mode).

C 426 does not respond to remote control

commands.

• Batteries are flat or incorrectly inserted.

• Check batteries.

• Infrared receiver (IR) window of the C 426 or IR

transmitter of the remote control is obstructed.

• Check IR windows and ensure clear line-of-

sight from remote control to C 426.

• C 426 front panel is in very bright sunlight or

ambient light.

• Reduce sunlight/room lighting.

RESTORING C 426 TO ITS FACTORY DEFAULT SETTINGS
1 Press and hold both the front panel [MEMORY] and [PRESET/TUNE] buttons until all VFD icons are illuminated.
2 Immediately press any front panel button; the C 426 will go to standby mode.
3 Press the STANDBY button to power up C 426 from standby mode; the C 426 is restored to its factory default settings with all Presets cleared/erased.

REFERENCE

TROUBLESHOOTING

LIS

LIA

РУ

СС