Napco Security Technologies XP-400 User Manual

Page 22

WI1370 XP-400 Installation Instructions

Site
At the site perform the following three steps:

1. Arm the panel.
2. Disarm the panel.
3. Enter

. The panel will now call

the download computer running
PCPreset. PCPreset will answer the
call, establish a connection, and then
download the account that matches the
Auto Download ID Number [93] with the
account of the same number in the list
that PCPreset is currently running.

Dealer Programming

[94]Dealer Code

The default Dealer Code is

4567

. Program

a new 4-digit Dealer Code. When the panel
is defaulted the Dealer Code will be
changed back to the default Dealer Code of

4567

only if Dealer Code Lockout [96-1]

has not been programmed.

[95]User 1 Code

The 1st User code is a program code as
well as an Arm/Disarm code. The default
User Code is

1234

. If User 1 Code Lockout

is programmed the User 1 Code cannot be
programmed from User Program Mode.

[96]Dealer Options 1

(1) Dealer Code Lockout - Program to
prevent the Dealer Code from changing with
a panel default.
(2) User 1 Code Lockout - If programmed
the User 1 Code cannot be programmed
from User Program Mode.
(3) Reserved
(4) Reserved

[97]Dealer Options 2

(1) International Dialing Protocol - No
dialing if no dial tone, 60 seconds between
attempts and 4 s wait for dial tone.
(2) Invert Bell Output - Inverts the Bell
polarity and removes supervision from the
bell circuit.

(3) System Trouble Auto Restore -
Normally, System troubles require
acknowledgment (View System Trouble) in
order to restore. If this option is selected
troubles will restore without requiring
acknowledgment.
(4) User 1 Code-Program only - If enabled
User 1 Code will function only as the User
Program Code and will not Arm/Disarm the
panel.

Note: All programming within Programming
Blocks [96] & [97] will not change if the
panel is defaulted.

[98] Number of Re-Dials

The Number of re-dial attempts made by the
panel before indicating a Fail-to-
Communicate.