Warning, E2 1 – NEC NP40CM User Manual

Page 8

ISSUED: 11-01-06 SHEET #: 055-9478-6 01-14-09

Visit the Peerless Web Site at www.peerlessmounts.com

8 of 8

For customer care call 1-800-729-0307 or 708-865-8870.

To adjust roll, pitch, and yaw loosen the set screw
(shown below) using security allen wrench (B) or
standard 4 mm allen wrench. You should be able to
just slightly loosen the screw so that your adjustments
can be set without having to hold the projector. Move
projector to desired position and slowly tighten set
screw.
Note: Be sure not to touch the projector while
tightening the set screw. This may cause the image
to be unaligned when you let go.

IMPORTANT: Allen wrench is your key for projector
removal. Store it in a safe place.

Peerless offers several Projector Mounts to fit various
projectors. New Projector Mounts are continually being
developed to meet the demands of a growing projector
market. To find out if a mount is available for your particular
projector, call Peerless customer service at 1-800-729-
0307 or 1-708-865-8870.

Note: The projector adapter plate and projector you are installing may differ in appearance from the sample
illustrated below.

SET SCREW

Attach projector, with adapter plate already on it, to the
ball and socket mount (A) by inserting the ball and
socket mount (A) into the adapter plate connection and
twisting until the adapter plate will no longer turn
(about 75°). The spring loaded captive screw should
line up with a corresponding hole on the adapter plate
(this should line up automatically when the two are
connected). Push down and tighten the spring loaded
captive screw to secure the adapter plate to the mount.
If not using the optional security feature, fasten thumb
screw (D) in the hole opposite the spring loaded
captive screw.

OPTIONAL: For Armor Lock

™

security, insert serrated

washer head socket pin security screw (E) in the hole
opposite the spring loaded captive screw. Tighten with
security allen wrench (B). This will prevent the
projector from being removed.
Note: Be sure to only use the #10-32 x 3/8" screw (E)
(or the thumb screw (D)) opposite the spring loaded
captive screw.

WOOD
JOIST

CEILING

PROJECTOR ADAPTER PLATE
(UL Listed PAP Series)
Sold Separately

PROJECTOR

WOOD
JOIST

CEILING

PROJECTOR

CUTAWAY VIEW OF
CEILING PLATE (G)

CAPTIVE

SCREW

• Do not lift more weight than you can handle! Use

additional man power or mechanical lifting equipment
to safely handle placement of the projector!

WARNING

All other brand and product names are trademarks or registered trademarks of their respective owners.