Operation – NAD C715 User Manual
Page 18
LISTENING TO EXTERNAL SOURCES
When appropriately connected to the applicable C 715 input, one can listen
to external sources such as a VCR, Media Player (MP), Tape Recorder and
other auxiliary components.
Toggle the [SoURCE] button to select [TAPE], [VIDEo], [AUX] or [MP] mode.
Refer to the above sections about “Identification of Controls – Front Panel”
and “Identification of Controls – Rear Panel” for additional information on
these external sources.
SETTING THE CLOCK
1 Press the [TIME MoDE] button. Toggle [TIME MoDE] to step through
the following modes:
Current time on time
Source Select off time
2 At “Current time” mode, toggle [TUNE / TIME] to set the current hour
– “hour” value blinks. Press [TUNE MoDE/SElECT].
3 “Minute” value blinks. Press [TUNE/TIME] to set the current minute. Press
[TUNE MoDE/SElECT]. The clock starts from “00” seconds.
NOTES
• The C 715 uses the 24 hour “military” clock.
• When no action is taken for 1 minute, the time adjust mode is cancelled.
• To cancel time mode setting, press [STOP].
SETTING THE ON/OFF TIMER
Adjust the clock before setting the timer.
1 Toggle [TIME MoDE] until “on time” is displayed in the VFD. At “on time”
mode, “hour” value blinks.
2 Toggle [TUNE/TIME] to set the desired “hour” setting. Press [TUNE
MoDE/SElECT].
3 “Minute” value blinks. Press [TUNE/TIME] to set the desired “minute”
setting. Press [TUNE MoDE/ SElECT].
4 “off time” appears on the VFD and “hour” value blinks. Repeat steps 2
and 3 above to set desired “off time”.
5 Press [TUNE/TIME] to select the SoURCE where these timer settings will
be applied.
6 Press [TUNE MoDE/SElECT]. Timer settings are now stored in the
memory.
OPERATION
USING THE C 715 – EXTERNAL SOURCES AND TIMER
18
EN
G
LIS
H
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LIA
N
O
D
EU
TS
CH
N
ED
ER
LA
N
D
S
SV
EN
SK
A
РУ
СС
К
И
Й