NuTone CT600 - Manual (Page 5)

HOW TO USE THE POWER BRUSH
NOTE:
CT600 Power Brush is not recommended for use on bare floors. Wand
release on Power Brush allows you to quickly disconnect wands and switch
to Combination Floor/Rug Tool for use on bare floors.
Always pick up hard or sharp objects by hand before using your Power Brush.
Items such as pins, hairpins, tacks, crayons and pencil stubs may damage the
brush roll or may break a belt.
HANDLE RELEASE
Push down on Power Brush handle release pedal;
pull wand/hose assembly back to comfortable work
position. Return the handle to the upright position
for storage.
HEIGHT ADJUSTMENT
Select height setting by depressing height
adjustment pedal to desired position: Extra-Low,
Low, Medium or High.
EDGE CLEANER
Brush extends full width for effective edge cleaning along both sides of nozzle.
To operate, simply run cleaner along edge board. Rubber bumper protects
furniture and baseboards.
TO CLEAN AGITATOR
NOTE: In order to keep cleaning efficiency high and to prevent
damage to your vacuum cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned according to the following schedule:
VACUUM CLEANER USE
CLEAN AGITATOR
Heavy (used daily) every week
Moderate (2-3 times per week) every month
Light (1 time per week) every 2 months
IMPORTANT
Disconnect vacuum cleaner from electrical outlet. Check
and remove hair, string and lint build-up frequently in the CT600 agitator and end
cap areas. remove any dirt or debris in the belt path area or in the brush roller
area. Carefully remove any string or debris located on the agitator or end caps.
Pile Height
Indicator
Pile Height
Pedal Handle
Release Pedal
Height
Adjustment
Pedal
CÓMO MONTAR LA ESCOBA
1. Encajar a presión las dos varillas
entrelazadas.
2. Empujar las varillas montadas dentro
del casquillo del mango de la escoba
de manera que los botones encajen en
su sitio.
3. Empujar el cordón dentro de los
canales.
4. Conectar el cordón de la escoba a la
conexión del tubo, alineando las
esquinas en ángulo del enchufe con el
receptáculo del tubo.
5. Encajar el extremo del tubo en las
varillas montadas, asegurándose de
que el cierre del botón esté puesto.
6. Cuando se esté listo para usarla,
conectar el tubo a la toma de la pared
de la aspiradora y enchufar el cordón
eléctrico en cualquier tomacorrientes
conveniente de 120 voltios.
Nota: Al usar el tubo de enchufe
directo NuTone CH610 con la tomas
electrificadas de la serie CI390, el
enchufar el tubo también conecta la
corriente de 120 voltios.
Button
Wand
Swivel Cord
Holder
Anilla giratoria
de la varilla
Varilla
Botón de la varilla
Pedal de
liberación de
la varilla
Botón
Portacordón
Anilla
giratoria
de la
varilla
AGITATOR ASSEMBLY