NEC XV29 Plus - Manual (Page 11)

Battery Installation and Replacement
The remote control is powered by two 1.5V AA batteries.
3. Close the battery compartment cover. 1. Turn the remote control unit upside down.
Press down on the battery compartment
grip and slide the compartment in the
direction of the arrow.
2. Install the two new batteries, making sure
that their polarity matches the (+) (–)
diagrams inside the battery compartment.
Incorrect polarity could damage the
remote control unit.
Remote Control Cautions
• Do not drop or mishandle the remote control unit.
• Do not get the remote control unit wet. If the remote gets wet, wipe it dry
immediately.
• Avoid heat and humidity.
• When not using the remote control unit for a long period, remove the
batteries.
• Do not use new and old batteries together, or use different types of
batteries together.
• Do not take apart the batteries, heat them, or throw them into a fire.
Operating Range
• The infrared signal operates by line-of-sight up to a distance of
approximately 22 feet/7 m and within a 60 degree angle of the remote
sensor of the monitor.
• The monitor will not function if there are objects between the remote
control and the sensor or if strong light falls on the sensor. Weak batteries
will also prevent the remote control from properly operating the monitor.
POWER POWER /STANDBY SOURCE SELECT VOLUME RGB2 VIDEO2
S
L (MONO) R AUDIO PROCEED EXIT
30˚ 30˚
79645721
POWER ON
RGB 2 RGB 1 VIDEO 2 VIDEO 1
POSITION / CONTROL PROCEED
EXIT
SCAN
NORMAL SIDE PIN HEIGHT WIDTH
BRIGHT CONTRAST MUTE
NORMAL
VOLUME
OFF DEGAUSS
MULTIMEDIA MONITOR
RD-346E
11
12